ºÚÁÏÍø

Mechanic JSA

 

Job Safety Analysis -  Mechanic

 

 

The following assessment has been prepared to assist Kent State staff in the identification of hazards that may be present in University work classifications. It is only a guide and should not be taken to imply that only the listed hazards are the only risk present in the applicable work classification. It is the responsibility of all employees, supervisors, and managers to constantly evaluate each work tasks (before, during, and after performance of the task) and identify any hazards that could be a danger to the worker and take steps to control, reduce, and/or eliminate the risk to the University worker.

 

Job Hazard

Hazard Control

Exposure to hazardous materials

Wear proper gloves and eye protection; avoid inhalation of fumes and dusts; complete Hazard Communication Training and Respiratory Protection; utilize localized and dilution ventilation

Improper handling of fuel and oil

Avoid contact; wear proper gloves; wash body thoroughly if contact is made; avoid inhalation of fumes; train in Chemical/Material Handling principles

Potential hazardous waste spill exposure

Train in spill control procedures

Flying debris (during engine runs, etc.)

Wear proper eye protection

Improper use of hand tools

Avoid using tools in situations that may cause pinching or smashing of hands or other body parts due to slipping or other accidents

Working with powered equipment: forklifts, carts, vehicles, grounds equipment, or vehicle lift

Train personnel in Vehicle/Forklift/Equipment safety practices

Potential electrical shock

Avoid working with energized equipment by utilizing Lockout/Tagout and Permits when appropriate

Maintenance, handling, and waste management of batteries

Battery charging and maintenance training

Heavy lifting, bending, pulling (batteries, equipment, parts)

Use proper lifting techniques, ergonomic principles, and/or assistive devices

Welding/grinding/cutting/brazing of metal parts

Wear long sleeve shirts, long pants, and eye protection; use proper machine guards and follow Hot Work Permit practices

Working on generators and batteries. Take arc flash and electrical training and wear arc flash PPE.

 

Recommended Training:

Hazard Communication

Fire Extinguisher Training

Waste Management

Battery Management

Automotive Lift

Forklift

Hot Work

Respiratory Protection

SPCC

LOTO

Flammable and Combustible Liquids

Machine Guarding

Defensive Driving

Back Safety

Ladder Safety

Slips, Trips and Falls

Compressed gas cylinders

Arc Flash

Occupational Noise

Asbestos Awareness

PPE

 

Personal Protective Equipment:

Steel toe safety shoes

Long Pants

Cotton shirt; use of polyester, acetate, nylon, or rayon-blend clothing is prohibited.

Impact-resistant safety glasses when grinding or brazing

Welding shield when welding